User's Manual

Marker being pumped – hammer and bolt traveling to the rear – ball ready to drop in breach.
The ball is temporarily held in place by the ball detents installed in your Series 6
marker (they are hidden under the little caps on the side of your marker that say
S6). When the cocking rod (attached to the hammer) allows the hammer to clear
the sear, the sear will catch (with a click).
Sear Engaged, Bolt moving forward ball entering the chamber.
At this point, move the pump forward (away from the rear of the marker). This
will move the bolt forward, which will push the ball past the detents and into the
breach / barrel of the marker.
Sear Engaged, Bolt at rest, ball in chamber.
This is one full cycle of the Series 6.
Note: This marker comes with an ‘auto-trigger’. The auto-trigger allows
the user to hold down the trigger and pump the marker – firing the marker