User's Manual

4. Clean (use your Q-tips® in all the appropriate places on the regulator top)
and replace the regulator Pin O-Ring if necessary. Apply a light coat of oil
to these parts and replace them.
5. Use your Needle nose pliers to pull out the Regulator Piston and O-ring
(marring the cone portion of the regulator piston is okay - just do not mar
where the regulator pin touches the regulator piston).
You can also take the Velocity Adjustment Screw out of the bottom and
push the piston out with a long rod.
6. Carefully dump out the Spring and Regulator Spring Seat (this may take a
few taps on your hand or a non-marring surface).
7. Unscrew the 3/16 adjustment screw from the bottom.