User's Manual

This is the CCM® internals set. From left to right – top to bottom: IVG, Main Spring,
Hammer and Lug, Valve Alignment Nut, Valve Body and Valve Body O-Ring, Valve Pin and
Cup Seal, Valve Spring.
14. Inspect the Valve Seal. If it appears damaged – replace it. These can
last a very long time, but dirt and other debris can cause them to fail. If
your marker is leaking down the barrel (and the cause is not the pressure
of the marker being too low) it may be a bad Valve Seal.
The good news and a great innovation by CCM is that the Valve Seal is
replaceable without scrapping the whole Valve Pin Assembly. An N70-
011 O-ring is used to repair a leak. Simply take apart the valve body from
the valve top hat (or base) carefully (it is held together with blue Loc-tite)
and snap on the O-Ring. Screw the pieces back together, using Loc-tite
again, and you are ready for the field.
15. Use a 1/16
th
Allen Key to remove the Wire Detent Screw (Series 5 Basic)
or both screws that retain the Detent Covers (S6). Inspect the rubber
detents (S6) and replace if necessary. These are Intimidator® Detents
and can be found at any competent pro-shop.