User's Manual

Remove the Trigger Shoulder Bolt and slide the trigger from the frame (shown

with the top Allen key). Also remove the Trigger Undertravel Screw (shown

with the bottom Allen key) - it must be removed from the top of the frame.

Use Blue Loctite® on these screws upon reassembly. Be sure not to over

tighten the Trigger Shoulder Bolt. Over tightening can cause drag on the

trigger.

Your trigger frame is now completely disassembled. Clean thoroughly and

reassemble.

Chassis Disassembly and Maintenance:

1. Remove the Bolt Pin, Bolt, and Cocking Rod.

2. Remove the back block by spinning it anti clockwise. Note how many

turns it took. This will ease reassembly.

3. Slide the Pump Handle and Pump Arm off the marker.