User's Manual

2. Remove the grip screws (4 - 5/64
th
) and the grip panels and the Frame
Screws (2 1/8
th
Allen Screws for the Series 5 Basic and 2 - 3/32
nd
for the
Series 6) that attach the frame to the marker chassis. The screws on the
Series 6 are submerged and thus can be simply loosened a turn or two and
the frame slid to the rear of the marker and removed. The Series 6 screws
are of two different lengths – ensure you replace these properly when
reassembling. Set the chassis aside.
3. Remove the Auto Trigger Arm and Cam from the .45 frame. Sometimes you
can simply rotate the AT arm to remove it - if it feels stuck you will most likely
have to back out the undertravel screw (see below).
4. Series 5 Basic – Pictured Carefully (the sear is under slight spring tension)
remove the sear retention pin. Simply push out the pin using a punch or a
small Allen key.
5. Step Four (Series 6 Frame - Not Pictured): Carefully (the sear is under
slight spring tension) remove the sear retention pin. There is a small grub
screw to remove and then a small pin can be used to push out the sear
retention pin.