User's Manual

Pump Arm:
Ensure that the bolt that attaches the Auto Trigger to the pump arm is perfectly
perpendicular to the pump arm or else you will get binding and marring of the
Auto Trigger arm.
Cocking Rod:
Set the cocking rod so that when you pump the marker the bolt just clears the
chamber (looking down the feedneck) when the marker cocks. In other words,
when you hear the click of the sear catching on the lug the bolt should have just
cleared the chamber allowing another ball to enter the chamber. If this is not this
way, or if the sear catches well beyond this point, adjust the cocking rod properly.
The cocking rod will be Loctite® d (Red). Make sure you have a non-marring vice
and some heat in order to loosen the setscrew that allows you to adjust the
cocking rod. In reality, the factory setting is usually proper. If it is close to being
as described above – leave it alone.