User's Manual

X. Velocity:
CAUTION: Industry approved protective gear (for face and eyes) must be worn at
all times while operating and performing adjustments on this marker.
• Do not insert objects into the space between the cocking block and the main
body of the marker at any point in time. Improper marker treatment may result
in damage to the marker and serious injury to the operator.
• Prior to beginning any work on your marker, check to make sure that all excess
pressure has been released by pointing the marker in a safe direction and
pulling the trigger. This is a necessary precaution because the marker may still
contain pressure even after the removal of the gas source.
• If you are uncertain, unable or do not know how to perform work on the marker,
have adjustments and repairs made by a qualified technician.
To adjust velocity:
1. Every CCM® I have owned has come from the factory set at about 290
F.P.S. In addition, every CCM® marker I have owned has come with the
regulator set at about 300 PSI from the factory. This may not be the case
with your S6. You may want to skip to the portion of this manual titled
“Setting up your Series 6”. However, you also may simply want to go out and
play. If the latter is the case – here is how to adjust your velocity.
2. Pump the marker to the most rear position and hold it there.
3. Insert the short end of a 1/8” Allen wrench into one of the three holes in the
IVG (Internal Velocity Governor). Turning the Allen wrench clockwise will
increase the velocity while counterclockwise will decrease velocity.
4. Movement of the wrench quarter turn in either direction will approximately
yield a 15-20 fps change.