User's Manual

8. Clean the bottom portion and replace the Regulator piston or Regulator
Piston O-Ring if necessary.
9. CCM® packs the lower portion in clear grease. I have found no grease is
necessary here and simply apply a coat of Dow® 55 or Hater Sauce on
the Piston and Piston O-Ring.
10. Put the regulator bottom back together and screw in the 3/16th screw flush
with the base of the reg.
11. Reassemble the regulator and check it. I use a simply pressure testing
kit. Set the Regulator at 300 PSI. If not simply follow the set up
instructions above.