User's Manual

To Adjust Velocity:
CAUTION: Industry approved protective gear (for face and eyes) must be worn at all
times while operating and performing adjustments on this marker.
• If you are uncertain, unable or do not know how to perform work on the marker, have
adjustments and repairs made by a qualified technician.
1. All CCM markers come from the factory with the regulator ‘sweet spotted’. This
means that the regulator is set to its most efficient point. Please do not attempt to
adjust the velocity by using the regulator. If you over pressurize the valve – it will
actually cause the markers velocity to go down not up. If you want to understand
more about the valve and its set up – please read the full CCM Manual.
2. If your marker needs the velocity adjusted – please pump the marker to the most
rear position and hold it there – exposing the IVG for adjustment.
3. Insert the short end of a 1/8” Allen wrench into one of the three holes in the IVG
(Internal Velocity Governor). Turning the Allen wrench clockwise will increase the
velocity while counterclockwise will decrease velocity.
4. Movement of the wrench quarter turn in either direction will approximately yield a 15-
20 fps change.
For how to clean, maintain, or trick out your new CCM marker – please read the manual
that accompanied your marker – or visit www.chipleymachine.com