User's Manual

CCM Marker - Quick Start Guide:

Congratulations on buying a CCM Marker! We at CCM have taken every effort to give

you a quality marker that is properly adjusted and performing at the highest level. The

marker you have in your hands should serve you for years to come with a little

maintenance and care. With this in mind, please do not disassemble or adjust this

marker before playing with it and understanding what you need to adjust. Even though

we have adjusted this marker – it is your responsibility to make sure it is shooting safely

before you hit the field. In order to do this please follow these steps:

1. Screw barrel onto marker – if your CCM marker does not come with a barrel – use a

barrel with Autococker® threads.

2. Place barrel blocking ‘Barrel Bag’ device properly onto the marker

CAUTION: Always wear paintball approved eye and face protection when dealing with a

pressurized paintball marker.

3. Pull the cocking rod back until it latches into place. You will hear a click when this

happens. If you do not follow this step the marker will leak down the barrel when you

connect the air source.

4. Connect the air source to the ASA (air system adapter.)

Note: Make sure to always get air cylinders filled by authorized, skilled

and knowledgeable technicians for the correct fill limits of each cylinder.

Do not try to refill cylinders by yourself. Do not use cylinders that have not

been properly maintained or that are damaged. It is very important that

caution be exercised when refilling or attaching cylinders.

5. Attach the loader to the feed port of the marker. CCM Markers come with a clamping

feed neck. This feed neck either has a lever style clamping feature or an Allen bolt.

This bolt takes a 5/32 Allen key. Clockwise tightens the band to your hopper.

Note: Use only 0.68 caliber paintballs in your CCM Marker. Do not modify the

paint in any way.

Before field use, ensure the velocity is in compliance with field safety guidelines.

General field velocity limits are usually between 250 fps to 300 fps (fps = feet per

second.) Your paintball markers velocity should never exceed 300 fps. Observe

and abide by all local laws, regulations and field safety guidelines pertaining to

use of paintball markers.

PAGE 1
CCM Marker - Quick Start Guide: Congratulations on buying a CCM Marker! We at CCM have taken every effort to give you a quality marker that is properly adjusted and performing at the highest level. The marker you have in your hands should serve you for years to come with a little maintenance and care. With this in mind, please do not disassemble or adjust this marker before playing with it and understanding what you need to adjust.
PAGE 2
To Adjust Velocity: CAUTION: Industry approved protective gear (for face and eyes) must be worn at all times while operating and performing adjustments on this marker. • If you are uncertain, unable or do not know how to perform work on the marker, have adjustments and repairs made by a qualified technician. 1. All CCM markers come from the factory with the regulator ‘sweet spotted’. This means that the regulator is set to its most efficient point.