User's Manual

VI. Installation of the CCM Internals Kit:
Step One:
Stack the Valve Spring, Valve, and Valve body, and Valve Retaining Nut on top
of the Valve Tool (CCM has these available) and slide the body over this
assembly.
Step Two:
Being sure to not cross thread the Valve Retaining Nut begin to screw the Valve
Retaining Nut into the body.
Step Three:
Turn the body of the marker over so that you can see the bottom. Whilst turning
the valve assembly with the Valve Tool line up the bottom of the valve (the small
divot – not the open hole) with the hole left by the removal of the Valve Alignment
Screw. This may take the use of another implement (a ball end Allen key works
well) to make sure that the valve body stays aligned. Only finger tighten the
Valve Retaining Nut at this point.