Manual

VII. Disassembly of a CCM Grip Frame for
Maintenance:
1. Remove the screw that attaches the auto trigger arm and cam to the
frame.
2. Remove the grip screws (4 - 5/64
th
) and the grip panels and the Frame
Screws (2 1/8
th
Allen Screws for the Series 5 Basic and 2 - 3/32
nd
for the
Series 6) that attach the frame to the marker chassis. The screws on the
Series 6 are submerged and thus can be simply loosened a turn or two
and the frame slid to the rear of the marker and removed. The Series 6
screws are of two different lengths – ensure you replace these properly
when reassembling. Set the chassis aside.
3. Remove the Auto Trigger Arm and Cam from the .45 frame. Sometimes
you can simply rotate the AT arm to remove it - if it feels stuck you will
most likely have to back out the undertravel screw (see below).
4. Series 5 Basic Frame – Pictured Carefully (the sear is under slight
spring tension) remove the sear retention pin. Simply push out the pin
using a punch or a small Allen key.