Manual

Step Four:
Screw the Back Block on to the Pump Rod until it is tight on the Pump Rod. It
might not tighten down on the Pump Rod and this is not essential. Just get it
close to the end of the threads.
Step Five:
Reinsert the Bolt, Bolt Pin, and Cocking Rod into the rear of the marker.
Step Six:
Place the new grip frame on the body and tighten down the front (1/8th inch) and
the rear bolts (3/32nd inch) (These might be different on your frame - the Basic
Frame has two 1/8th screws and the new S6 Frame has two 3/32 screws.)