User's Manual
4
Step 2
Place the nut in the hexagon hole on the sensor, then
insert the screw in other side and tighten it by the screw
driver.
Step 3
Insert the other side of the pole to the square hole of the
plastic stand.
NOTE:
Ensure the pole and stand's indicator align.
Step 4
Place the nut in the hexagon hole of the stand, then
insert the screw in other side and then tighten it by the
screw driver.
Install the wireless 7-IN-1 sensor in an
open location with no obstructions above
and around the sensor for accurate rain
and wind measurement. Install the sensor
with the smaller end facing the North to
properly orient the wind direction vane.
Secure the mounting stand and clamps
(included) to a post or pole, and allow
minimum 1.5m o the ground.
1.5 meter o
the ground
Point to
NORTH
Add rubber
pads before
mount on the
pole