User's Manual

26
LIGHT INTENSITY (Note: Data detect by 7-in-1 sensor)
Light intensity unit Klux, Kfc and W/m²
Display range 0 ~ 200Klux
Resolution Klux, Kfc and W/m² (2 decimal place)
Memory modes Historical Data of past 24 hours, Max
Weather Index (Note: Data detect by 7-in-1 sensor)
Weather index mode Feels like, Wind Chill, Heat Index and Dew point
Feels like display range -65 ~ 50°C
Dew point display range -20 ~ 80°C
Heat index display range 26 ~ 50°C
Wind chill display range -65 ~ 18°C (wind speed > 4.8km/h)
Memory modes Historical Data of past 24 hours, Max / Min
WIRELESS 7-IN-1 SENSOR
Dimensions (W x H x D) 343.5 x 393.5 x 136mm (13.5 x 15.5 x 5.35in) installed mounting
Weight 673g (with batteries)
Main power 3 x AA size 1.5V batteries ( Lithium batteries recommended)
Weather data
Temperature, Humidity, Wind speed, Wind direction, Rainfall, UV and light
intensity
RF transmission range 150m
RF frequency (depend on
country version)
915Mhz (US) / 868Mhz (EU, UK) / 917Mhz (AU)
Transmission interval
- 12 seconds for UV, light intensity, wind speed and wind direction data
- 24 seconds for temperature, humidity and rain data
Operating temperature range -40 ~ 60°C (-40 ~ 140°F) Lithium batteries required for low temperature
Operating humidity range 1 ~99% RH
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a n a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.