YPV6 Series Mobile Air Conditioner Operation Manual •• YPV6-12C&YPV6-14C Thank you for your choice of this high-quality mobile air c r. Please read this manual carefully before use. For problems if any, please contact professional servicemen.
Table of Contents User Instructions Precautions..........................................................................................................................................1 Important Safety Tips..........................................................................................................................3 Special Remarks...................................................................................................................................
USER INSTRUCTIONS The meaning of icons used in this manual is as follows: For your and your families’ health and safety, please do not perform such operations. For your and your families’ health and safety, please do perform the following issues. Precautions This machine is only for household, please do not use for other purposes. Please use this machine indoor and put it in dry environment. Do not use outdoor.
1/2 Please do not operate this machine with wet hands or in humid environment. Please wipe this machine with soft cloth, and waxes, diluents or irritant detergents are prohibited for use. nt ts ita en Irr erg t e D ts en lu Di Please clean strainer frequently, and once per two weeks is recommended. For your health, please do not drink condensate drained from this machine. If this machine is not used for long time, please disconnect power plug.
Important safety tips Please do not damaged power lines or plugs; please do not insert power line into loose socket. Do not damage or use damaged and type unknown power lines. Before use, please make sure the voltage applied is in compliance with the requirements. Do not modify and extend power line without authorization. Grounding socket is recommended when running this machine. Please do not insert and extract power line plug with wet hands since such operation may cause electric shock.
3/4 Do not control on/off status of the machine through insertion and extraction of power plug. Please shut down the machine before extracting plug. Please do not share one power socket with multiple large-power appliances. Please keep this machine away from direct sunlight. On condition that the machine sends out strong noise or smoke, please shut it down immediately and disconnect plug and check reasons.
Please do not insert fingers or hard objects into air deflecting strip at the air Please do not allow water to enterelectric part of this machine. If water enters inside of the machine, please shut it down immediately and disconnect plug, and then contact professional servicemen for maintenance. If wiping, cleaning and moving the machine or replacement of machine components is required, please shut down and disconnect power plug first.
5/6 Special Remarks A space of at least 50cm should be maintained between the air conditioner and surrounding objects, and meanwhile air inlet and outlet should be kept unimpeded. 50cm Place the air conditions on flat ground, and keep vertical to guarantee normal operation of compressor. 50 cm Please do not use this machine in the vicinity of gasoline or other flammable liquids.
PRODUCT INTRODUCTION Components and Parts 1 3 2 4 2. Control panel 3. Air outlet 4. Caster 5 4 5. Side plate 5 8 6 7. Air inlet 7 8. Remote control 3 9 10. Power cord 10 11. Drain cover 11 Heat 12. Exhaust pipe assembly 13.
7/8 Components and Parts 7 6 2 5 1 4 1. Power on/off key Pressing this key can turn on/off the air conditioner. 2. Mode selection Pressing this key can select refrigeration, air supply, dehumidification and auto modes. 3. °C/°F Conversion key Pressing this key can realize display conversion between°C and°F. 4.
USE OF PRODUCT Storage - Place this machine on horizontal floor close to window; - In order to maintain perfect ventilation and achieve the best performance, a space of at least 50cm around the machine should be reserved; Installation Exhaust pipe assembly Installation kit assembly Step 1: 1. Measure dimensions of window; 2. Adjust the length of window seal plate to make it fit dimensions of window; 3. After determination of the length of window seal plate, fix its length dimension with screw.
9/10 Step 3: Screw exhaust pipe assembly (exhaust joint end) into the air outlet on rear panel (in anti-clockwise direction). Step 4: Small notch Click exhaust pipe assembly (exhaust flat nozzle end) into installation kit assembly and fix with screw.
Warning: The length of exhaust pipe is especially designed for this type and should not be replaced or extended without permission, otherwise failure may be caused. Attention: The max spread length of exhaust pipe is 1500mm, please reduce the length as much as possible during use, and remaining exhaust pipe level as much as possible during installation is recommended. Remote Control Before use of remote control, please install cells in correct way. The specific steps are as follows: 1.
11/12 Operating method Refrigeration mode • After power-on startup take refrigeration mode as default or press mode key to select refrigeration mode, and refrigeration indicator lamp is on. • Pressing UP/DOWN key can regulate setting temperature (17°C~30°C). • Pressing air speed key can select high, medium or low air speed. Air supply mode • Pressing air speed key can select high or medium or low air speed. • Temperature cannot be set.
CLEANING AND MAINTENANCE Drainage method This product is provided with automatic water evaporation system. Condensate circulation cools condenser. This not only improves refrigerating efficiency, but also saves energy. If water container inside the machine is full of water, the display screen will flash show “FL” with sound alarm, compressor stops operation automatically. At the moment water should be drained, and the specific steps are as follows: 1.
13/14 Filters Cleaning of strainer once per two weeks is recommended, and the cleaning frequency should be properly increased if indoor air quality is bad. Jamming of strainer by dust will reduce efficacy of the air conditioner. The specific cleaning steps are as follows: 1. As per the direction shown in figure below, first remove air-inlet grille, and then remove strainer; 2.
Seasonal maintenance If this machine is in idle for long time, please maintain it as per the following steps: 1. Extract water plug at the water outlet to drain water. 2. Keep the air conditioner running in air supply mode or 2h till the inside is blown dry. 3. Shut down and disconnect plug. 4. Clean strainer and re-install. 5. Dismantle accessories including exhaust pipe, etc. and keep properly. 6. Take the cells out of remote control. 7.
15/16 COMMON FAILURES AND DIAGNOSIS Intelligent Detection of Failures Detection codes Multifunction detection E1 Failure of coil temperature sensor E2 Failure of indoor temperature sensor E4 Anti-freeze protection: when coil temperature is lower than 0℃, shut down whole machine. As coil temperature rises again above 8℃, the protection is relieved and the original operating state is resumed.
