User manual CC_SHBR12

Cc-Smart Technology Co., Ltd
5. Configuration:
DIP SWITCH MODE Configuration:
The smart H-Bridge support many type of communication method such as PWM/DIR, PPM,
UARTs,...They combine the input Pin to saving the connection. The Driver will use DIP
SWITCH to config witch type of communication you use. Please configuration Dip Switch
Mode before turn on the power.
Dip switch mode configuration:
When power on or changing mode. The Run LED in the PCB will blinking a X sequence
number to confirm witch mode are configured. X = 1 (PWM 50/50), X=2 (PWM/DIR),…,
X=6 (ANA/JOY)
Acceleration/Deceleration Configuration:
This feature will support to reduce a sudden changing of velocity. They will protect the mechanical
and electrical in many cases.
The ACCE/DECCE depend on a Variable Resistors ACCE value in PCB. Please see below picture to
know the ACCE Enable/Disable Zone (Disable Zone: No apply ACCE/DECCE).
2.
PWM/DIR
1 2 3 4
3.
ANA/DIR
1 2 3 4
4.
UART
1 2 3 4
5. RC Mode
1 2 3 4
6. ANA JOY
1 2 3 4
ACCE Disable
ACCE Enable
MAX
1.
PWM 50/50
1 2 3 4