Users Manual
Ant.
Port
Brand
Model Name
Antenna Type
Gain (dBi)
2
3
C
1
- ALC140-052030-A PIFA
3
2
3
D
1
-
ALC160-051020-000000
Print
3.33
2
ALC160-051021-000000
3.76
E
1
-
GY196HT625-001
Print
1.73
2
GY196HT625-002
1.84
F
1
-
ALO160-052030-A
PIFA
3.54
2
ALO160-052030-A
3.41
G
1
Master Wave 660023500G Dipole
2.38
2
2.38
H
1
WNC 81XCBB15.G01 PIFA
1.28
2
1.28
I
1
WNC 81XCBB15.G02 PIFA
1.18
2
1.18
J
1
Sevio NTW01 Dipole
2.2
2
2.2
Note: Other types of antennas and/or higher gain antennas shall only be authorized by Permissive
Change procedures
3. RF exposure considerations
The end product must clearly indicate the operating requirements and conditions that must be
observed to ensure compliance with current FCC RF exposure guideline.
Mobile: (§2.1091) (b) — A mobile device is defined as a transmitting device designed to be used in
other than fixed locations and to generally be used in such a way that a separation distance of at
least 20 cm is normally maintained between the transmitter’s radiating structure(s) and the body
of the user or nearby persons.
Per §2.1091(d)(4) In some cases (for example, modular or desktop transmitters), the potential
conditions of use of a device may not allow easy classification of that device as either Mobile or
Portable. In these cases, applicants are responsible for determining minimum distances for
compliance for the intended use and installation of the device based on evaluation of either
specific absorption rate (SAR), field strength, or power density, whichever is most appropriate.
Note: If the final host/end product is intended for use as a portable device, the host
manufacturer is responsible for separate approvals for the SAR requirements from FCC Part
2.1093.
4. Information on test modes and additional testing requirements
1. This module is restricted to integration into hosts for indoor use only.
2. This module has been approved under stand-alone configuration.
3. OEM integrator has be limited the operation channels in channel 1-11 for 2.4GHz band.
4. The separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations.
5. The information on how to configure test modes for host product evaluation for different