FCC Regulatory Information for the Module This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
Ant. Port C D E F G H I J 2 1 2 1 2 1 2 1 2 1 2 1 2 1 2 1 2 Brand - Model Name ALC140-052030-A ALC160-051020-000000 ALC160-051021-000000 GY196HT625-001 GY196HT625-002 ALO160-052030-A ALO160-052030-A Antenna Type Gain (dBi) PIFA Print Print PIFA Master Wave 660023500G Dipole WNC 81XCBB15.G01 PIFA WNC 81XCBB15.G02 PIFA Sevio NTW01 Dipole 3 3 3 3.33 3.76 1.73 1.84 3.54 3.41 2.38 2.38 1.28 1.28 1.18 1.18 2.2 2.
operational conditions for a stand-alone modular transmitter in a host, versus with multiple, simultaneously transmitting modules or other transmitters in a host can be found at KDB Publication 996369 D04. 5. Additional testing, Part 15 Subpart B disclaimer Appropriate measurements (e.g. 15B compliance) and if applicable additional equipment authorizations (e.g. SDoC) of the host product to be addressed by the integrator/manufacturer. This module is only FCC authorized for the specific rule parts 15.
FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Industry Canada statement: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.
OEM integrator is still responsible for testing their end product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.). IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop configurations or co-location with another transmitter), then the IC authorization is no longer considered valid and the IC No. cannot be used on the final product.
The transmitter module may not be co-located with any other transmitter or antenna. Le module émetteur peut ne pas être coïmplanté avec un autre émetteur ou antenne. CAN ICES-3 (B)/NMB-3(B) The Country Code Selection feature is disabled for products marketed in the US/Canada For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.
