WL-1201M IEEE 802.11b Wireless LAN USB Module Hardware Installation Guide Version 1.
WLAN USB Module Installation Guide REGULATION INFORMATION The WLAN USB Module must be installed and used in strict accordance with the manufacturer’s instructions. This module device complies with the following radio frequency and safety standards. FCC (Federal Communications Commission) This module device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: 1. This module device may not cause harmful interference. 2.
WLAN USB Module Installation Guide Table of Contents 1 2 3 4 Introduction .................................................................................................................... 4 Technical Specification of WLAN USB Module ........................................................... 4 Installation ...................................................................................................................... 5 PCB Drawing and Module Mounting ..............................................
WLAN USB Module Installation Guide 1 Introduction Thanks for you purchasing Wireless Local Area Network (WLAN) USB module. You are about to install a networking system that is not only fast and powerful, but also easy to set up and simple to maintain. In a short time you and those in your network will be able to share a local printer and files, access the Internet, and roam about the office wire-freely.
WLAN USB Module Installation Guide 3 Installation This section describes the procedures for installing the Wireless LAN USB module on your product/system. Before You Start Before installation, please check your system in advance and ensure it meets the minimum requirements as described below. - Processor: Intel Celeron / Pentium II /Pentium III / Pentium IV; AMD Duron / Athlon - Operating System: Microsoft Windows 98 / ME / 2000 / XP/ Linux - System memory: 32MB at least. - Hard Drive Free Space: 5MB.
WLAN USB Module Installation Guide 4 PCB Drawing and module Mounting.
