User Manual

3. Windows Installation

The following section will assist you to install Wireless LAN USB successfully. You will

first install software (driver) and then connect the Wireless LAN USB, and finally set

the network properties to accommodate resource sharing and select the type of

wireless network that you wish to install. The Wireless LAN can easily be installed and

used, without bothering to connect cables for keeping your computer to use network

resources, as in case of wired LAN.

Before You Start

Here are some steps you will perform in establishing your wireless network

connection:

• Install the Access Point at first. AP is needed in case of infrastructure

network mode.

• Install the software using the Installation CD ROM

• Install the Wireless LAN USB Dongle

• Install the network protocol(s) required to communicate on your network.

Most likely you will need the TCP/IP protocol.