User's Manual

USER’S MANUAL OF WLAN TRAVEL AP/ROUTER Version: 1.0
55
Item Description
L2TP Allow user to make a tunnel with remote site directly to
secure the data transmission among the connection. User
can use embedded L2TP client supported by this router to
make a VPN connection.
Dynamic IP (DHCP) Click the checkbox to enable Dynamic IP (DHCP).
Static IP Click the checkbox to enable Static IP.
IP Address If you select the L2TP support on WAN interface, fill in
the IP address for it.
Subnet Mask If you select the L2TP support on WAN interface, fill in
the subnet mask for it.
Default Gateway If you select the PPTP support on WAN interface, fill in
the default gateway for it.
Server IP Address Enter the IP address of the L2TP Server.
User Name If you select the L2TP support on WAN interface, fill in
the user name and password to login the L2TP server.
Password f you select the L2TP support on WAN interface, fill in
the user name and password to login the L2TP server.
Connection Type Select the connection type from pull-down menu. There
are Continuous, Connect on Demand and Manual three
types to select.
Continuous connection type means to setup the
connection through L2TP protocol whenever this WLAN
Broadband Router is powered on.
Connect on Demand connection type means to setup the
connection through L2TP protocol whenever you send
the data packets out through the WAN interface; there are
a watchdog implemented to close the L2TP connection
while there are no data sent out longer than the idle time
set.
Manual connection type means to setup the connection
through the L2TP protocol by clicking the Connect
button manually, and clicking the Disconnect button
manually.
Idle Time If you select the L2TP and Connect on Demand
connection type, fill in the idle time for auto-disconnect