User's Manual

- 3 -
GETTING TO KNOW YOUR PRINTER COMBO ADAPTER
Printer combo adapter supports two interfaces which can be used to connect
with your printer.
1). IEEE-1284 - It is a 36-pin male connector on the front. Connect it to
your printer. If your printer hides its female connector inside its case, then you
have to open it.
2). USB - It is a USB type A connector. You need to connect one end of the
USB cable to printer combo adapter, then connect another end to the printer.
Note: If your printer supports both interfaces, we recommend you to choose
just one to connect with printer combo adapter. If you connect printer combo
adapter to both of them, 1284 interface will be the functioning one.
3). Apply power to printer combo adapter by using the power adapter
accompanied.
4). RESET button is to re-initialize the printer adapter, it is normally left
unused. You also can un-plug the power adapter, then plug it again to get the
same result.
FUNCTION OF LEDS DURING PRINTING
POWER LED
Power LED turns on when POWER is applied to printer combo adapter.
BLUETOOTH LED
Bluetooth LED is blinking when Bluetooth link is established but no data is
transmitted on the line.
Bluetooth LED is ON when PC is wirelessly sending data to printer through
printer combo adapter.
PRINTER LED
Printer LED is ON when there is a USB or parallel (IEEE-1284) printer
connected to the printer combo adapter.
Printer LED is OFF when no printer is connected.
Printer LED is blinking when PC is sending data to printer through printer
combo adapter.