User Manual

Step 6: Select Master, enter Bluetooth MAC

Address of Remote device which will be

Pairing and connecting with; input PIN code

“0000”.

Click ADVANCE to change UART Baud Rate,

Stop Bits and UART Parity.

Step 7: Select UART Baud Rate, Stop Bits and

UART Parity.

Press OK button

Then press SET button

1.2. Configuring RS-232 Serial Adapter on PC 2:

Step 1: Connect a DCE RS-232 Serial Adapter to COM1 Port of PC1. Apply power to it.

Step 2: Push Mode Button until the MODE LED lights, then it enters Configuration Mode.

Step 3: Launch RS-232 Serial Adapter Utility-

Cable Replacement Config Tool.exe on PC2.

Step 4: Select COM1 Port which RS-232 Serial Adapter is

connected.

We assume it is the first time you are

configuring this RS-232 Serial Adapter, you can choose

the default Baud Rate: 115200

Press Connect Button.

Step 5: If it connects successfully, the yellow light

appears, if the connection fails, the red light

appears.

While the connection is done, Cable

Replacement Config Tool loads all of the setting

from the RS-232 Serial Adapter.