Setup guide

CBM OPOS Driver Setup Guide
-17-
Setting List of Memory Switch
SW No. CT-S300-RF
SW No.
CBM-262II-RF CBM-262II-PF
1-1 Power ON Info OFF
1
Receipt print density — Receipt print density —
1-2 Buffer Size OFF
2
Journal print density — Journal print density —
1-3 Busy Condition OFF
3
Cover Opoen Sensor Valid Cover Opoen Sensor Valid
1-4 Receive Error OFF
4
Auto Cutter Valid Auto Cutter Valid
1-5 CR mode OFF
5
Auto Loading — Auto Loading —
1-6 Reserved OFF
6
Receipt Paper Near End — Receipt Paper Near End —
1-7 DSR Signal OFF
7
Journal Paper Near End — Journal Paper Near End —
1-8 Init Signal OFF
8
CR Control Ignore CR Control Ignore
2-1 Reserved ON
9
Reset by INIT Invalid
2-2 Auto Cutter ON
10
Reset by DSR Invalid
2-3 Spool Print OFF
11
Error Handshake Invalid Error Handshake Invalid
2-4 Full Col Printing ON
12
Input Buffer 8KB Input Buffer 8KB
2-5 Resume aft PE OFF
13
High Quality Print — High Quality Print —
2-6 Paper width —
14
Country U.S.A Country U.S.A
2-7 Reserved OFF
15
Caracter Set — Caracter Set —
2-8 NPE Sensor OFF 16 CBM262 Compatible Invalid CBM262 Compatible Invalid
3-1 Resume Cttr Err OFF 17 Power On Data Set Valid Power On Data Set Invalid
3-2 Resume Open Err OFF 18 Stop Bit —
3-3 Parallel 31PIN OFF
3-4 Paper Select OFF
3-5 Column Number —
3-6 No use OFF
3-7 CBM1000 mode OFF
3-8 Open w/Printing OFF
4-1 Auto Length OFF
4-2 BM Sensor OFF
4-3 No use OFF
4-4 No use OFF
4-5 No use OFF
4-6 No use OFF
4-7 No use OFF
4-8 Full Cut Cmd OFF