User`s manual

User’s Manual
37
3.3.14 AUTOPAN
Auto-pan means motion of scanning an area horizontally so that the PTZ Camera
can catch horizontal view. The parameters are listed as follows.
• AUTOPAN LINE
There are four sets of auto-pan line built in a PTZ Camera. Users can choose
a line to execute using LEFT/RIGHT direction keys. In addition, users are
able to command the camera to do endless panning by setting the start point
the same as the end point.
• START POINT
Follow the description to set the start position of the AUTOPAN path.
1. Move the cursor to <START POINT> and press <ENTER> while <TO
FIND> is flashing. Then the item will turn <TO SAVE> automatically.
2. Move the PTZ Camera to the desired position and press <ENTER> to save
the position as the start point; the cursor will move to <END POINT>
automatically. Set the end point to complete the auto-pan setting.
NOTE: The tilt and zoom values of the start point will be recorded
and fixed for the selected auto-pan line.
• END POINT
The user can set the end point once the start point has been defined. Pan the
PTZ Camera to another position and press <ENTER> to save the position as
the end point.
• DIRECTION
This option is used to set the AUTOPAN direction of the PTZ Camera. If you
select <RIGHT>, the camera will start to pan clockwise from the start point to
the end point and then return to the start point. If you select <LEFT>, the
camera will start to pan anticlockwise from the start point to the end point.
Refer to the diagram below.
AUTOPAN
AUTOPAN LINE 1
START POINT
TO FIND
END POINT
TO FIND
DIRECTION RIGHT
SPEED 1
RUN AUTOPAN ENTER
EXIT
YES