User`s manual

User’s Manual

be the same. The default RS-485 setting is half-duplex. Please do not change the

default setting without seeking the advice of a qualified specialist or the supplier. The

SW 3 and SW 4 are used for termination and line lock adjustment respectively. The

SW 5 is mainly used when users want to restore the camera to the factory default

status; moreover, once firmware upgrade is carried out, users also need to reset the

SW 5 afterward.

RS-485 setting

Half-duplex

Full-duplex

2.4 PTZ Camera ID Setting

Use the switch to change your PTZ Camera ID by turning the arrow to the desired

number. For example, if the camera ID is 123, the ID switch should be set as below.

NOTE: No two cameras should be given the same ID, or communication

conflict may occur.

Hundreds Tens Units

NOTE: The number “0” should be located at the top as shown in the diagram

above to ensure correct switch definition.

2.5 PTZ Camera Control Protocol

A protocol is a specific set of rules and procedures used for data communication.

Define the protocol you are going to use based on the devices in your surveillance

system. Generally, you should use a single protocol even if the devices are supplied

by different manufacturers. Use the switch to set your PTZ Camera control protocol

and the baud rate. Refer to the table below and turn the arrow to choose a protocol for

your camera.