User`s guide

Using the Command Line Interface Cayman 3220-H User’s Guide
4-6 December 2000
configure
Puts the command line interface into Configure mode, which lets
you configure your Cayman 3220-H with Config commands. Config
commands are described starting on page 4-15.
diagnose
Runs a diagnostic utility to conduct a series of internal checks and
loopback tests to verify network connectivity over each interface on
your Cayman 3220-H. The console displays the results of each test as
the diagnostic utility runs. If one test is dependent on another, the
diagnostic utility indents its entry in the console window. For
example, the diagnostic utility indents the Check IP connect to
Ethernet (LAN) entry, since that test will not run if the Check
Ethernet LAN Connect test fails.
Each test generates one of the following result codes:
download [server_address] [filename] [confirm]
Copies the current configuration settings of the Cayman 3220-H
from a TFTP (Trivial File Transfer Protocol) server. The TFTP server
must be accessible on your Ethernet network.
You can include one or more of the following arguments with the
download command. If you omit arguments, the console prompts
you for this information.
 The server_address argument identifies the IP address of the
TFTP server from which you want to copy the Cayman 3220-H
configuration file.
PASS The test was successful.
FAIL The test was unsuccessful.
SKIPPED The test was skipped because a test on which it
depended failed.
PENDING The test timed out without producing a result. Try
running the test again.