User`s guide

Cayman 3220-H User’s Guide Configuring Your Cayman 3220-H
December 2000 3-57
To configure bridging:
1. Click the Bridge Option On button.
You must enable bridging to enter other bridge settings.
2. Click the On for each network interface you want to
include in the bridged network.
The list of interfaces on which you can enable bridging is
created dynamically, based on which network interfaces and
virtual circuit connections you have set up in the Cayman
3220-H. You must enable at least two interfaces when you use
bridging.
3. If you want to restrict bridged traffic over an interface to
PPP over Ethernet packets, click the PPPoE-Only Filter On
button for the appropriate network interface.
If bridging over an interface is enabled but the filter setting for
an interface is off, all packets are passed across the interface.
4. If you want to bridge traffic between virtual circuit
connections, click the VC-to-VC Bridging On button.
For example, if you want to set up a bridged network to connect
several locations, you would enable bridging for each virtual
circuit connecting your location to the other locations.
5. Click the Save button to store your modified
configuration in the Cayman 3220-H memory.
6. Click the Restart Cayman-DSL button on the Cayman
3220-H Home Page to restart your Cayman 3220-H with its
new configuration.
Configuring
SNMP Settings
The Simple Network Management Protocol (SNMP) lets a network
administrator monitor problems on a network by retrieving settings
on remote network devices. The network administrator typically
runs an SNMP management station program on a local host to obtain