User`s guide

Configuring Your Cayman 3220-H Cayman 3220-H User’s Guide
3-42 December 2000
 RIP-2– Multicast routing information in RIP version 2
format.
 RIP-1 Compatibility – Broadcast routing information in RIP
version 2 format.
You cannot use RIP when network address translation is turned
on.
14. Use the RIP-Receive list to specify whether you want the
Cayman 3220-H to accept Routing Information Protocol
(RIP) messages from other routers.
RIP lets your Cayman 3220-H learn about routes available
through other routers. Options are:
 Off – Do not accept RIP messages from other routers.
 RIP-1 – Accept routing information in RIP version 1 format
from other routers.
 RIP-2– Accept multicast routing information in RIP version
2 format multicast by other routers.
 RIP-1 Compatibility – Accept routing information in RIP
version 2 format broadcast by other routers.
You cannot use RIP when network address translation is turned
on.
15. Use the IP Gateway radio buttons to specify whether you
want this virtual circuit to use a gateway.
16. If you selected On in Step 10, use the Gateway Type list to
specify the type of gateway.
Options are:
 Fixed IP Address – The IP gateway for this virtual circuit has
a fixed IP address.
 PPP Port (VCC #) – The IP gateway for this virtual circuit is
accessible over the specified point-to-point link.
17. If you selected Fixed IP Address in Step 11, use the Gateway
Address field to specify the IP address of the default IP
gateway.