User`s guide

Cayman 3220-H User’s Guide Diagnostic Console
December 2000 B-7
revert
The revert command retrieves the saved version of settings from
non-volatile storage and overwrites any changes made since the last
save.
save
The save command saves the EPROM settings you have entered or
changed to non-volatile storage in the Cayman 3220-H.
show
The show command displays the current EPROM settings for the
Cayman 3220-H and a brief explanation of those settings. For
example, the show command produces the following:
BootPROM> show
flash on (flash will be tried)
ip 0 (no ip address; tftp will not be tried)
file <unset> (must be set for tftp download)
bootp on (will attempt configuration via bootp)
autoboot 10 (will autoboot on powerup, and will try
10 times)
autoprog never (will never program a downloaded
image into flash)
Cayman 3220-H serial no. 800700, h/w rev. 1, eprom v1.3
Last install status: code flash successfully programmed
flash image 1: Cayman 3220-H 5.3.0
Boot Setting
Commands
The following commands specify boot settings for the Cayman
3220-H.
autoboot { retry_count | off }
The autoboot retry_count command (where retry_count is any
whole number) sets the number of times the Cayman 3220-H should
attempt to start an image and run it when powered up. If you enable
autoboot with the autoboot retry_count command, the