User`s guide

Using the Command Line Interface Cayman 3220-H User’s Guide
4-20 December 2000
CONFIG
Commands
This section describes the keywords and arguments for the various
CONFIG commands.
ATM Settings You can use the command line interface to set up each ATM virtual
circuit.
set atm option { on | off }
Enables or disables ATM services in the Cayman 3220-H. You must
enable ATM services before you can enter other ATM settings for the
Cayman 3220-H. If you turn off ATM services and save the new
configuration, the Cayman 3220-H clears its ATM settings.
set atm vcc n option { on | off }
Enables or disables a virtual circuit in the Cayman 3220-H (where n
is a number in the range 1-8). You must enable a virtual circuit before
you can enter other settings for it.
set atm vcc n vpi vpi
Specifies the virtual path identifier for the circuit. Enter a number in
the range 0-255.
set atm vcc n vci vci
Specifies the virtual circuit identifier for the circuit. Enter a number
in the range 0-65535.
set atm vcc n encap { ppp-vcmux | ppp-llc | ether-vcmux |
ether-llc | ip-vcmux | ip-llc }
Specifies the encapsulation method for the circuit. Options are:
 ppp-vcmux - PPP over ATM, VC-multiplexed
 ppp-llc - PPP over ATM, LLC-SNAP
 ether-vcmux - RFC 1483 bridged Ethernet, VC-multiplexed