User`s guide

Using the Command Line Interface Cayman 3220-H User’s Guide
4-18 December 2000
If a command is ambiguous or miskeyed, the CLI prompts you to
enter additional information. For example, you must specify which
virtual circuit you are configuring when you are setting up a Cayman
3220-H.
Dogzilla (ip)>> ip-ppp
ip-ppp (?) [vcc1 | vcc2 | vcc7 | vcc8]: vcc1
Dogzilla (ip ip-ppp [vcc1])>>
Displaying Current
Router Settings
You can use the view command to display the current CONFIG
settings for your Cayman 3220-H. If you enter the view command at
the top level of the CONFIG hierarchy, the CLI displays the settings
for all enabled functions. If you enter the view command at an
intermediate node, you see settings for that node and its subnodes.
Stepping Through
Cayman 3220-H
Configuration
The Cayman 3220-H command line interface includes a step mode to
automate the process of entering configuration settings. When you
use the CONFIG step mode, the command line interface prompts
you for all required and optional information. You can then enter the
configuration values appropriate for your site without having to
enter complete CLI commands.
When you are in step mode, the command line interface prompts
you to enter required and optional settings. If a setting has a default
value or a current setting, the command line interface displays the
default value for the command in parentheses. If a command has a
limited number of acceptable values, those values are presented in
brackets, with each value separated by a vertical line. For example,
the following CLI step command indicates that the default value is
off and that valid entries are limited to on and off.
Numbers Enter numbers as integers.
IP addresses Enter IP addresses in dotted decimal notation (0
to 255).
Command
component
Rules for entering CONFIG commands