Manualshelf

Installation Sheet

ManualsBrandsCavity Sliders ManualsHardwareSingle Action Carriage Pack with 2 Stop for Doors 176 to 264 Pounds
1234
1 Prepare the doors.
Drill two holes in the positions as marked (right).
Screw both mounting plates to the door with the
plunger pins facing towards the edges of the door.
Make sure they are placed exactly in the center of the
door thickness.
At the bottom of the door, cut a groove to the
dimension and tolerance shown. Make it central of the
door thickness and absolutely straight.
2 Bi-Parting (double) doors.
The mounting plate with the black plastic stop fits
nearest to the leading edge of the door.
3 Fix the T-Guide.
Fix the T-Guide to the floor so that it is not visible
when the door is in the pocket. The front edge of the
T-Guide should sit flush with the final casings.
1
PAGE
These instructions cover the preparation of doors
to be fitted into a pocket that has the
CS SofStop Track fitted.
Read through the notes carefully before beginning
as different mounting plate positions and setups
may be required for different configurations.
Go to page 2 (overleaf)
IMPORTANT
The CS SofStop carriages require a clean track running
surface free of any contamination or damage.
After installation but before lining, clean the full length
of the inside running surface of the track with a soft
rag, then TAPE UP THE TRACK to ensure no dust or
debris enter the track during building works.
Never drill, nail or screw through the center section of
the track. Make sure no dirt, grit or aluminum swarf
gets into the track. This could impair the smooth
running of the carriages.
Installation
Instructions
© Cavity Sliders USA Inc. Drawings are not to scale.
PREPARING DOORS - Single
PREPARING DOORS - Bi-Parting
(double) or Mount Plate with Stop
5-5.5mm
(1/4”)
20-21mm (13/16”)
Black
plastic
stop
T-Guide
85mm
(3-3/8”)
to center
85mm
(3-3/8”)
to center
Drill ø25mm (1”)
13mm (1/2”) deep
Leading
edge of
door
Mounting
plate
Leading
edge of
door
85mm (3-3/8”)
to center of
boss hole
for both
carriages
150mm (6”) to
center of boss
hole
Plunger
pin
Plunger
pin
Fit screws as
shown
Fit
screws
as
shown
20-21mm (13/16”)
5-5.5mm (1/4”)
SUGGESTED
T-GUIDE
PLACEMENT
Door
T-Guide
Casings
Pocket framing
Drill ø25mm (1”)
13mm (1/2”)
deep

Summary of content (4 pages)