Installation guide

Page 9
Advanced Preparations:
Be familiar with the controls of the range hood by reading 1.
through Range Hood Operations, Page 12.
Place the range hood on a at, stable surface. Connect the 2.
range hood to a designated standard outlet (please refer the
product label for the suitable voltage of this unit) and turn on
the range hood. Verify all operations of the range hood by
referring to Range Hood Operations, Page 12.
Place all supplied parts and required hardware on a at, stable surface and verify the existence of all supplied 3.
parts listed on Page 4.
Carefully remove the white plastic protective coat from the chimney covers and range hood.4.
Preparations:
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
Determine and mark the center line on the ceiling where the range hood will be installed. Make sure there is 1.
proper clearance within the ceiling or wall for exhaust vent.
Due to the weight and size of this unit, please make sure that the support system or framework being used is 2.
stable and secure in the wall.
Put a thick, protective covering over counter top, cook top or range to protect from damage or dirt. Remove 3.
any hazardous objects around the area when installing.
Mark the locations of the support mounting bracket holes, vent cutout (if used) and power supply cable cutout 4.
on the ceiling. Use drill and saber saw or keyhole saw to cut openings for power supply cable and vent (see
Venting requirements and Electrical requirements, Pages 5-8).
If venting to the outside install vent system (see 5. Venting Methods, Page 7). Use caulking to seal exterior wall
or roof openings.
Disconnect main electrical supply, prepare and run electrical wiring through ceiling or wall. Leave approxi-6.
mately 12” of electrical cord hanging from the ceiling. Do not restore power until wiring is completed.
Disconnect power cord, remove the aluminum lter by pressing on the latch toward the direction of solid ar-7.
row while holding the metal handle, gently pull the aluminum lter toward the direction of dashed arrow as
shown in Figure 1.
Remove the grease cup by sliding it sideway, see Figure 2 for location of the grease cup.8.
Set aside the aluminum lters and grease cup until the range hood is properly installed.9.
If the range hood comes with a glass canopy and has not already been mounted to the hood, loosen the four 10.
canopy screws and washers from the hood top, carefully place the canopy on the hood top, and loosely tighten
the four canopy screws along with washers. DO NOT put excessive pressure against the glass.
Figure 1
Figure 2
WARNING
Severe Injury
Rotating fan can cause severe
injury. Stay clear of fan when
motor is running.
Preparation
WARNING
Excessive Weight
Require three or more person to move and
install this range hood. Spinal or other bodi-
ly injuries could occur if it is not followed.