User manual

Operating Instructions
Legend™ 1200E Spot User Manual 17 8/13/2009 10:57 AM
Menu Map
Main Function
Sub Function
Selection
Instruction
DMX Functions
DMX Address
1~512
DMX starting address assignment
DMX Channel Mode
Mode 1 (23)
Operating mode: Basic
Mode 2 (31)
Operating mode: Advanced
View DMX Value
View the DMX input values (only from the starting address
through the last channel of the mode (23/31)
Fixture Settings
Pan Inverse
Yes/No
Inverts the Pan operation from 540 ~ 0
Tilt Inverse
Yes/No
Inverts the Tilt operation from 270 ~ 0
Bl.o. P/T Moving
Yes/No
Enables Blackout while pan/tilt moving
Bl.o. Color Change
Yes/No
Enables Blackout while Color moving
Bl.o. Gobo Change
Yes/No
Enables Blackout while Gobo moving
Auto Focus
Yes/No
Enables auto focus while zooming narrow/wide
Lamp Settings
On/Off
On/Off
Manual Control of the lamp state
State/Power On
On/Off
Automatically strikes the lamp upon powering on the fixture
Off Via DMX
Yes/No
Allows remote Lamp Off commands to be received via DMX
On if DMX On
Yes/No
Strikes the lamp if DMX is present
Off if DMX Off
Yes/No
Turns off the lamp if DMX is not present
Cooling Mode
High
Maintains the fans at highest speed, regardless of lamp
temperature
Auto
Maintains the lowest (most silent), possible fan speed, according
to the lamp temperature
Ignition Delay
0s~255s
Delays striking the lamp to allow for lower inrush currents
Low Power Delay
0s~255s
Sets the time activating delay between the shutter/dimmer
closing and the lamp power reduction. The maximum delay is
255 seconds
Display Settings
Display Inverse
Yes/No
Inverts the display graphics 180°
Back Light Auto Off
Yes/No
Turns off the backlight after several seconds of being idle
Back Light Intensity
1~10
Sets the backlight intensity from dim to bright
Temperature Unit
°C
Displays the temperature in Celsius
°F
Displays the temperature in Fahrenheit
Fixture Test
Auto Test
Runs the fixture, testing each function in series
Manual Test
Manually controls each function of the fixture directly from the
control panel without a DMX controller; used for
testing/troubleshooting purposes only
Fixture
Information
Fixture use time
Displays the amount of time the fixture has been operating
Lamp On Time
Exit
Exits this function
Reset Time
Resets the lamp time (used when replacing the lamp in the
fixture)
Firmware Version
Displays the firmware version of each software chip
Reset Function
Pan & Tilt
Yes/No
Resets the pan & tilt, independent of the other motors
Color
Yes/No
Resets the color wheel, CMY, & 3200 K (CTO) dichroic flags,
independent of the other motors
Gobo & Iris
Yes/No
Resets the gobo & iris, independent of the other motors
Shutter & Dimmer
Yes/No
Resets the shutter & dimmer, independent of the other motors
Focus & Zoom
Yes/No
Resets the focus & zoom, independent of the other motors
Prism & Frost
Yes/No
Resets the prism & frost, independent of the other motors
All
Yes/No
Resets all motors in the fixture simultaneously
Special
Functions
Fixture
Maintenance
Interval
User can set the custom time for this Warning message
Remain Time
Shows the time remaining from the current interval user time
Factory Settings
Yes/No
Resets all settings to the factory defaults, with the exception of
the motor offset settings