User manual

Setup
Legend™ 1200E Spot User Manual 10 8/13/2009 10:57 AM
3-Pin to 5-Pin
Conversion Chart
It may be necessary to use a 3-pin to 5-pin adapter. Please see the chart below
for further explanation.
3-PIN TO 5-PIN CONVERSION CHART
Conductor
3-Pin Female (Output)
5-Pin Male (Input)
Ground/Shield
Pin 1
Pin 1
Data ( - ) signal
Pin 2
Pin 2
Data ( + ) signal
Pin 3
Pin 3
Not used
Pin 4
Not used
Pin 5
You may use the 3-pin input with the 5-pin output. You may also use 5-pin
input with the 3-pin output. However, you may NOT use both the 3-pin and the
5-pin outputs simultaneously.
DMX Data
Connection
The fixture uses the DMX data connection for its DMX 23 & 31 Channel modes.
See the “Introduction” chapter for a description of the two DMX Channel modes
and the “Operation Instructions” chapter to learn how to configure the fixture
appropriately for this mode.
1. Connect the male connector of the first DMX cable to the DMX Output connector
(female) of the DMX controller.
2. Connect the, female connector of the first DMX cable coming from the controller
to the DMX Input connector (male) of the first fixture.
3. Connect the male connector of the second DMX cable to the DMX Output
connector (female) of the first fixture.
4. Connect the female connector of the second DMX cable coming from the first
fixture to the DMX Input connector of the second fixture.
5. Continue linking the other fixtures in the same way.
DMX Data
Connection
Diagram
CHAUVET Certified
DMX Data Cables
Order Code Description
DMX1.5 DMX Cable 1.5 m/4.9 ft
DMX4.5 DMX Cable 4.5 m/14.8 ft
DMX10 DMX Cable 10 m/32.8 ft
2
nd
fixtures
1
st
fixture
DMX
Output
DMX
Input
DMX
Input
DMX
Output
Universal
DMX
Controller
1
st
DMX
Cable
2
nd
DMX
Cable
3
rd
DMX
Cable
Next fixture