Instructions / Assembly

STEP 6
Door Assembly
STEP 7
Brace Prep
3/4” Pin
Install 3/4” pins in brace ends
1 1/2” Long 3/16” DIA. Steel Pin
4 used in
this step
5/8” Phillips Flat Head #8 Screw
3 used in this step
Magnet Plate
7/8” Truss Head Machine Screw
2 used
in this step
1/2” Phillips Flat Head #4 Screw
1 used in this step
5/8” #8
A. Tap/insert ONE 1 1/2” pin into
each end of both doors. DON’T
OVERDRIVE PINS! Pins should
stick up about 1/2” when seated.
B. Attach the door spacer to the
left door with 5/8” #8 screws.
The spacer has a space at the
top to allow magnet clearance
and is almost ush with the
bottom of the door. Countersunk
holes out.
C. Attach the magnet plate
(may be stuck to magnet!)
with the 1/2” #4 screw to the
top of the right door. Bumps go
toward the wood.
D. Attach door handles with
7/8” truss head machine screws.