Instructions / Assembly

1 1/2” Long 3/16” DIA. Steel Pin
4 used in
this step
5/8” Phillips Flat Head #8 Screw
3 used in this step
Magnet Plate (1)
1 1/4” Truss Head Bolt
2 used
in this step
1/2” Phillips Flat Head #4 Screw
1 used in this step
ILLUSTRATION 1
3/4” Long 3/16” DIA. Steel Pin
4 used in this step
ILLUSTRATION 2
1/2” #4 Screw
5/8” #8 Screw
1 1/2” Pin
3/4” Pin
STEP 1
A. Tap/insert one 1 1/2” pin into
each end of both doors. DON’T
OVERDRIVE PINS! Pins should
stick up about 1/2” when seated.
B. Attach the door spacer to the
left door with 5/8” #8 screws. The
spacer has a space at the top to
allow magnet clearance and is
almost ush with the bottom of
the door.
C. Attach the magnet plate (may
be stuck to the magnet!) with the
small at head screw to the top
of the right door. Bumps toward
wood.
D. Attach door knobs with two
1 1/4” truss head bolts.
STEP 2
Take the 2 front braces and tap/insert one 3/4” steel pin into each
of both braces until seated. About 3/8” will stick out when seated.
OK if loose.