Instructions / Assembly

STEP 1
1. Attach the Rack Top to the top ends of the Side Panels (universal: same left/right & top/bottom)
using 1 1/4” #8 wood screws. MAKE SURE YOU HAVE THE RACK TOP! The only difference
between the Rack Top and the Cabinet Top is that the Cabinet Top has 4 small pilot holes on the
bottom side plus the 4 through holes; whereas, the Rack Top only has the 4 through holes.
NOTE: On the Rack Top the countersunk (reamed out) through holes face up and the countersunk
holes/pilot holes on the Cabinet Top face down. The countersunk holes allow the screw heads to be
ush with the wood surface when tightened down.
2. Turn this assembly upside down so that the Rack Top is on a smooth at surface. Attach the
Cabinet Top with four 1 1/4” #8 wood screws. With the unit upside down at this point, the 4 pilot holes
should be up. See illustration 1B.
3. Leave this assembly UPSIDE DOWN and go to STEP 2.
NOTE: The cart cabinet will be constructed upside down
using the bottom of the Cart Top as the base.
1 1/4” Phillips Flat Head #8 Screw
8 Used in this step
RACK TOP
CABINET TOP
PILOT HOLES HIDDEN
CABINET TOP
RACK TOP
ILLUSTRATION 1A
ILLUSTRATION 1B