Instructions / Assembly

STEP 9
Attach handle/towel bar to side panel with 1” #8 screws/washer
from inside one panel.
2 used in this step
1” Phillips Flat Head #8 Screw
2 used
in this step
3/16” Flat Washer
1 1/2” Long 3/16” DIA. Steel Pin
4 used in
this step
5/8” Phillips Flat Head #8 Screw
3 used in this step
Magnet Plate
7/8” Truss Head Machine Screw
2 used
in this step
1/2” Phillips Flat Head #4 Screw
1 used in this step
STEP 10
A. Tap/insert ONE 1 1/2” pin into
each end of both doors. DON’T
OVERDRIVE PINS! Pins should
stick up about 1/2” when seated.
B. Attach the doorspacer to the
left door with 5/8” #8 screws. The
spacer has a space at the top to
allow magnet clearance and is
almost ush with the bottom of the
door. Countersunk holes out.
C. Attach the magnet plate (may
be stuck to magnet! ) with the 1/2”
#4 screw to the top of the right
door. Bumps go toward the wood.
D. Attach door handles with 7/8”
truss head machine screws.