User guide

STEP 12
A. Insert and tap caster sockets with hammer until the
teeth grab the wood. DONT POUND SOCKET
FLAT OR CASTER SHAFT WILL NOT ENTER.
B. Insert casters and seat by pushing
straight downward with heel or your hand,
or tap into place with a hammer. Dont be
afraid to give them a good downward
whack on the solid metal part of the
caster!
C. Locking wheels usually go on back,
but can go diagonally or on the front if
cart is moved a lot.
ILLUSTRATION 14
STEP 13
A. Upright Unit. Take bottom
shelf ( no edge banding )
and place it on the set of
back pins. Close doors and
shelf will drop into place.
B. Decide on position of
middle shelf, then tap two
1 pins into each side panel,
making sure the pins on both
sides are in the same relative
position. To remove a pin, use
pliers or claw hammer.
C. Place middle shelf, edge
banding out, on pins.
ILLUSTRATION 15