C R A F T S M E N, I N C. Assembly Instructions Model 1447-1446 This unit is made of solid North American hardwood and has a factory applied oil finish. See the enclosed booklet for care instructions.
Model 1447/1446 Parts List P/N: TT1447/1446 (1) Table Top 58” x 28” x 1-3/4” P/N: HEX WRENCH1447/1446 (1) P/N: LCB1447/1446 (1) Lower Center Brace 39-1/2” x 3” x 3/4” HEX WRENCH P/N: SKRU 1-1/4 (10) 1-1/4” #8 FLAT HEAD SCREW P/N: UFBB1447/1446 (2) Upper Front & Back Braces 39-1/2” x 5” x 3/4” P/N: TTS1447/1446 (2) Table Top Stick 15” x 3/4” x 3/4” P/N: SKRU 2 HEX (12) 2” HEX SCREW Included with Model 1446 30” Height Table Only P/N: Side1447 (2) Side 34” x 18” x 1” P/N: Side1446 (2) Side 28” x 1
Model 1447/1446 Assembly Instructions To make the assembly of your new Catskill Craftsmen unit go as smoothly as possible, lay out all of the components prior to beginning assembly. Make sure you have all the pieces necessary, if there are any missing or damaged parts, call us at 607-652-7321 for replacements. Read instructions thoroughly before beginning assembly to make sure you have a full comprehension of how to proceed from step to step.
2 3 Using the 1-1/4” #8 Flat Head screws, attach the Table Top Sticks. Make sure the sticks are positioned such that sticks have counter sunk holes facing each other. Using the 1-1/4” #8 Flat Head screws, attach the Table Top to the base.
Diagram 4-1 4 Using a hammer, tap the Leveler feet into the bottom of each side as shown in diagram 4-1, approximately one inch away from each end. 6 ED C U RED O OUR T E S! C I R R E P M O T CUS Using a hammer and a buffer (like another block of wood, an old book or some other hard item that will not scratch into the wood when hammered) tap the wooden plugs into place to cover the hex screw holes. Carefully right the harvest table and move into your desired location.
