Hand Wand Features: Power footrest control, power headrest control, power lumbar control, heat, massage, USB, and LED backlight. LED Backlight: The buttons are each equipped with an indicator LED that will light up when pressed.
Foot Buttons: When held down, the Foot “Open” button will recline the furniture. To stop the furniture in the desired comfort position simply release the button at any time. When held down, the Foot “Close” button will bring the furniture out of the reclined position and return to the normal upright seated position. To stop the furniture in a particular position simply release the button.
Home Button: When held down, the “Home” button will return the furniture to the normal closed position by closing the head, foot, and lumbar motors. Massage Mode Button: Pressing the massage button will activate the vibrating massage feature of the furniture. The massage mode button will cycle through the two massage modes; steady and pulse. Massage Mode: Pulse By default the massage feature starts on the “pulse” mode and “medium” intensity.
Massage Mode: Steady Pressing the massage button a second time will change the massage mode to “steady”. The “steady” mode will turn on all of the massage motors, the motors in “steady” mode will run constantly. The Steady massage mode is indicated by the BLUE LED under the Massage Label on the hand wand. Again, the medium intensity setting is indicated by the BLUE LED on the intensity label on the hand wand.
Massage Intensity Button: Pressing the intensity button again will change the massage power from RED (High) to GREEN (Low). Heat Button: Pressing the heat button will activate the heating pad. This button will also cycle though the 3 heat settings; Low, Medium, and High. By default the heating button will start on RED (High) mode. Heat Button: Pressing the heat button again will cycle the heat setting from RED (High) to BLUE (Medium).
Heat Button: Pressing the heat button again will cycle the heat setting from BLUE (Medium) to GREEN (Low). Off Button: When pressed, the off button will stop both the heating and massage functions. 18-20 Minutes Safety Timer: This system is protected by a safety timer that will shut the heating and massage functions off after approximately 18-20 minutes of runtime.
USB: Always consult the owner’s manual of any device before plugging it into the included USB charbig port.
Furniture Assembly Instructions Your furniture is shipped with the Back Frame disconnected from the rest of the furniture. Step 1. To connect the Back Frame of the furniture, simply align the female KD brackets (also called KD sleeves) on the Back Frame with the male KD brackets at the back of the Seat/Arm Frame and push down to lock in place. When the bracket is successfully locked into place you will hear an audible “click” confirming that the locking tab has been engaged. Step 2.
