Installation & Assembly

Roll the chair onto its arms, underneath the chair there is a red bag with the power supply, cut the white zip tie securing the bag to
the lift frame. Remove the power supply from the bag (dispose of the bag properly). Plug the extension cord into the power
supply, ensure the cord is routed so that it will not be trapped in the mechanism…
While the chair is upside down, ensure that all (4) of the adjustable floor glides are in place…also ensure that they are tight, they
can be adjusted to even out the chair on uneven floors if necessary…but for setup make sure they are secure.
Roll the chair back into the upright position, locate the handwand in the magazine pouch. The handwand is stored in the magazine
pouch when not in use. The chair is now ready to be plugged in, use caution whenever plugging any device into a electrical outlet.