120 Self-Flushing Self Washing Cat Litter Box - Manual Set Up

WARNING: Do NOT use
an extension cord with
your CatGenie. This can
be hazardous.
4. Plug the CatGenie electric
cord into a GFCI certied wall
outlet. GFCIs are required by
code for baths, laundry rooms
and wet areas.
RUNNING YOUR CATGENIE
RIGID
PIPE
1. Complete water in
and waste out set up,
as directed on previous
pages.
2. Empty entire Washable Granules Box into
the Bowl. Box lls to level indented inside the
Bowl. Spread Granules out evenly. Only use
CatGenie Washable Granules.
3. Insert SaniSolution Cartridge into the slot on top of
the Unit. Notch points to back.
NOTE: Your CatGenie cannot function with an empty
Cartridge. Always have an extra Cartridge on hand.
TIP: In Cat Activation mode, the Cartridge is good
for 240 washes. On other settings, it is good for 120
washes.
5. When plugged in, a series of beeps
sounds and all LEDS light up in a
sequence. This means CatGenie is
working correctly.
NOTE: If none of the LEDs light, check
if the Processing Unit is securely in
place. Lift it up and replace it into its
slot. Check the electric connection.
If still not lighting, call Customer
Support at 1-888-735-3927.
WHAT TO EXPECT DURING CLEANING:
1. Scoop Cycle: GenieHand scoops 3 times to remove solids.
NOTE: Ridges on the GenieHand purposely rub against a
post on
the Brim so that excess Granules get shaken back
into the Bowl.
The
clicking sound it makes is normal.
2. Wash Cycle: After scooping, water and SaniSolution ow
in to cover Washable Granules. SaniSolution, Water, and
GenieHand scrubs Granules and Bowl. GenieHand moves to
agitate Granules. Solids get liqueed inside the Hopper. Water
and waste drains out. Interior is rinsed clean.
3. Dry Cycle: Air dryer blows warm air as GenieHand sifts
through Granules for thorough drying.
Total cycle time: ~38 minutes
If something does not run properly, or
your CatGenie is giving you an alert,
troubleshoot using the Operation Manual,
pages 20-21. If that does not work, Call
Customer Support at 1-888-735-3927.
GO TO PAGE 7 FOR NEXT STEPS
WARNING: DO NOT use or mix cat litter in
the CatGenie. Litter causes severe damage
to the CatGenie and voids your Warranty.
IMPORTANT: MAKE SURE YOUR
CATS ARE NOT NEARBY WHEN
YOU FIRST RUN THE CATGENIE.
6. Press Start to run
a Cleaning Cycle
to see if your setup
is correct and to
observe the Unit’s
operation.
7