120 Self-Flushing Self Washing Cat Litter Box - Manual Operation

BEFORE TAKING STEP 2, take your CatGenie apart.
TIP: This part is messy. Wear gloves.
Pull out Hopper. If dirty or filled with water open the Hopper above the
Bowl, then put it in or on a bucket or on newspapers. Clean out any hair
or debris around the Impeller. Be careful not to lose the HairCutting Ring
and the Red Washer. In a sink or tub, thoroughly wash the Hopper.
STEP 2. CLEAN THE HOPPER INSIDE & OUT...
CLEAN INSIDE THE BASE.
A dirty job that maintenance prevents.
1) Remove Hopper Cover and
Processing Unit. Rest Unit on
a towel. Lean it against a wall.
2) Unclip the GenieHand.
3) Push its Clip though the Brim.
4) Remove Brim by pushing on
Knob for leverage. Pull up back
5) to release Brim from Base.
www.catGenie.com 1-888-735-3927
18
Remove all Granules from every nook and cranny inside and out
and around the Hopper. Replace HairCutting ring, teeth down, on ridge
inside the Hopper. Close the cleaned Hopper. Wash the Red Washer.
Dab with liquid soap or baby oil. Proceed to Base cleaning.
Remove Bowl. If the Bowl is filled with wet Granules, place it in a trash bag to avoid leaks. Close bag to prevent cats from using the Granules.
Remove GenieScrubber from Base. Dump the dirty water from the Base. Be careful. Keep the DrainHose in the drainpipe or toilet.
If you have to move the Base in order to dump the water, remove the DrainHose and hold it above (higher than) the Base to avoid leaks.
Once the Base is empty, REPEAT STEP 1 parts B and C on page 17.
CLEAN THE BASE. Clean/wash out all Granules from all parts of the Base, especially the Slot where the Hopper sits and the hole into the
DrainHose. Once all is cleaned and cleared, coil the Hose under the Base as shown in photo to avoid clogs.
ASSEMBLE THE CATGENIE: Put the Drain Hose in toilet or drainpipe. Add the Hopper now, so you can see that the Red Washer is in place.
Put GenieScrubber, feet up, into the Base. Replace the Bowl, make sure it is centered and rotates. Now add the Brim and the GenieHand
in its up position. Before replacing, check the bottom of the Processing Unit for orange niplet. RETURN TO PAGE 17. FOLLOW F and H.
fresh water Intake
wastewater drain
Keep
Bowl of wet
Granules in a trash bag
If you must move the Base
to empty it,
hold the Hose
up higher than
the Base.
Remove
Granules from
every nook &
cranny
*
*
*
If you can’t clean the Base at this time, OR it’s not possible for you to dump the dirty water, go to page 17. Repeat STEP 1 parts B and C.
Then return here, page 18, to
ASSEMBLE THE CATGENIE, see just above and follow those steps. Because the dirty water was not
emptied, it will be difficult to replace the Hopper. Push it down, slowly. Once assembled, return to page 17 and follow F and H.
IMPORTANT: This short cut is not the solution. Not following the proscribed cleaning steps will cause a second clog. It is...
MANDATORY that you must Repeat Step 2 , page 18, very soon, before running more than 2 regular Cycles. Your chances of having
another clog on top of the partially cleared one is almost guaranteed.
Under the
Base, coil
DrainHose
loosely
around the
center knob
Scrubber goes
feet up and off
center
REMEMBER, you can always call us for help. 1-888-735-3927. Have your Serial #