User's Manual

ENG-54

Setup mode

Select the sensor ID to be checked.

Select from “HR (heart rate sensor)”, “SP1 (speed sensor 1)”,

and “SP2 (speed sensor 2)” pressing the MODE1 and MODE2

buttons, and then conﬁrm it pressing the SSS button.



SP1



SP2:

MODE2

MODE1

(or)

Conﬁrm :

SSS

SP2* is used when a wristwatch is commonly used for 2

bicycles. Once you synchronize the ID of the second bicycle

equipped with a sensor with SP2 in advance, the wristwatch

can identify the second bicycle automatically.

Press the SSS button to start searching for the ID.

When you select “SP1” or “SP2”, press the RESET button on

the speed sensor. When you selected “HR”, wear the heart

rate sensor (page 13), or transmit a sensor signal according

to the following simple method below.

When the heart rate or speed/cadence is displayed with

“ID-OK” on the screen, synchronization is completed.

Start searching :

SSS

This unit enters the search mode for 5 minutes after starting *

the ID sync. Press the SSS button in the search mode to

cancel the ID synch, and “ID-SKIP” is displayed. If any sen-

sor signal is not received in 5 minutes, “ID-ERROR” is dis-

played. When “ID-SKIP” or “ID-ERROR” is displayed, the ID

has not been synchronized properly.

*Even when the heart rate sensor is not worn,

it transmits a heart rate signal by rubbing both

electrode pads with your thumbs.

Pressing the

MENU button conﬁrms the change, and returns

to the Setup mode “SYNC ID”.

Press the MENU button repeatedly to switch to another mode.

To the mode top/switch the mode:

When you use * SP2, set the tire circumference of (Sensor 2) according to “Setting

the tire circumference” (page 52).

Electrode pad