User's Manual
ENG-21
Before use
Continue
Formatting/Restarting operation
There are 2 different wristwatch set-up operations; formatting and restarting operations.
Follow the appropriate one depending on the situation.
Formatting :
When you want to delete all data and the setup of the wristwatch.
Restarting : When you use the unit for the first time after purchasing, or after replac-
ing batteries, or an error is displayed.
In the restarting operation, the following data are retained.*
SPORTS MENU Date
OPTION MENU Setting the target zone
DATA MENU
UÊ ->Ûi`ÊwiÊ`>Ì>
UÊ ,`iÊ`>Ì>
UÊ }Ê`>Ì>
SETUP MENU
UÊ >ÀÊVVÊÃiÌÌ}
UÊ /ÀiÊVÀVÕviÀiViÊ>`Ê
Sensor currently selected
UÊ -iÃÀÊ
UÊ i>ÃÕÀiiÌÊÕÌ
UÊ ,iVÀ`ÊÌiÀÛ>
UÊ ÕÌ`i
UÊ /À>}ÊvÕVÌ
UÊ -Õ`ÊÃiÌÌ}
UÊ -i>ÊiÛiÊ>ÌÌÕ`i
Flows of the formatting and restarting operations
The formatting and restarting procedures are as follows.
In the case of the formatting operation, you can set the “tire circumference” *
and “measurement unit” sequentially after you set the “clock/date”. Each
set-up procedure is described on the page referenced.
After you complete the set-up, be sure to synchronize the sensor ID according
to the Setup mode “Searching for sensor ID” (page 53).
For restarting:
The date when last executed the restarting *
operation will be initially displayed.
Restarting operation (page 14)
Setting the clock/date (page 15)
Clock mode
For formatting:
Formatting operation (page 14)
Setting the clock/date (page 15)
Selecting measurement unit (page 18)
Tire circumference input (page 16)