Introduction How to Charge How to Mount CatEyeSYNC™ Compatible Rechargeable Safety Light SL-NW100 Switch Operation Manual Firmware Update Frequently Asked Questions Information in the instruction manual is subject to change without notice.
Install CatEyeSYNC™ SYNCWearable™ is capable of the following when used with the CatEyeSYNC™ smartphone app.
Checking package contents Light unit + Clip bracket Rubber band and hook USB cable (MICRO USB) Before Initial Use This unit is shipped with small charge to check the light. Be sure to charge it before use, according to the instructions “How to Charge” (Page 3) and “Cautions on recharging” (Page 11). How to Charge 1. Connect the light unit to your PC or a commercial USB battery charger using the USB cable. The indicator turns on and charging starts.
Charge jack cover 1 2 USB cable To PC or USB battery charger Indicator Steady red light : Charging Off : Charging is completed Flashing red light : Remaining battery low Standard Approx. 2.5 h (USB2.0) charging time * When your PC is in sleep state, the unit cannot be charged. * Use a USB battery charger of 500mAh (USB2.0) or more. The cartridge can be fast-charged with high capacity USB battery charger. 2. Once charging is complete, be sure to disconnect the USB plug.
Light unit + Clip bracket Install 1 Click 2 Remove Clip bracket 1. Confirm the jack cover of the light unit facing the clip bracket tab, and snap the unit on the bracket. 2. Remove the unit from the bracket by turning the unit to the left or right. How to mount to a bicycle Seatpost Rubber band and hook 1 OK NO 2 Mountable diameter range: Approx.
Switch Operation Press the switch to turn the light on/off or to select the mode. OFF High 30 lm ON *2 Click Switch Press and hold Low (Approx. 1.5 hours) Daytime HyperFlash 50 lm (Approx. 18 hours) Flashing 50 lm 50 lm (Approx. 45 hours) (Approx. 25 hours) Group Ride 2 lm Rapid (Approx. 12 hours) 50 lm (Approx. 16 hours) *2 When turning the light on, it lights up in the mode that was used last time.
Firmware Update Update Notifications When a new firmware version is available, CatEyeSYNC™ will show a notification. Firmware update notification Installing and Executing Firmware Updater for CatEyeSYNC™ To update the firmware, install Firmware Updater for CatEyeSYNC™ on your PC. * The PC must be connected to the Internet. Operating environment : Windows 7 / 8 / 8.1 / 10, or Mac OS 10.
3. Download the updater from the CATEYE website. Download location Home page SUPPORT Downloads Software and App Firmware Updater for CatEyeSYNC™ 4. Download the Firmware Updater for CatEyeSYNC™ that matches your OS. After download is complete, follow the on-screen instructions to install. Executing Firmware Updater for CatEyeSYNC™ * The PC must be connected to the Internet. 1. Fully charge the light being used. Important : Please make sure the light is fully charged before updating the firmware. 2.
3. Follow the on-screen instructions to connect the light to a PC and update the firmware. Important : • Be sure to use the included USB cable when • • connecting a light to a PC. Do not simultaneously connect any other lights. Do not power off the PC or disconnect the light while updating. Doing so may damage the light. Click [Update] button to begin updating. Wait until a dialog appears with the message [Updating complete]. 4. After the update is complete, disconnect the light.
Frequently Asked Questions The firmware update does not finish, or an alert is displayed. Try updating the firmware again from the beginning. * Please make sure the light is fully charged before updating the firmware. * Be sure to use the included USB cable when connecting a light to a PC. * Do not simultaneously connect any other lights. Appendix Warning!!! • Check periodically to ensure that the light unit is attached securely. Do not use a damaged rubber band.
Caution! • Stop your bicycle to operate the switch. • Do not place it within children’s reach. • This unit is not totally waterproof. Please wipe and dry it completely after using in rain. Otherwise, it may cause failure. • If the light unit or parts become dirty with mud, etc., clean with a soft cloth which is moistened with mild soap. Never apply paint thinner, benzine or alcohol; damage will result.
• If the illumination time is significantly reduced even after proper charging, the rechargeable battery may be nearing the end of its service life. Dispose of the battery as described in “Cautions for dispose”. Cautions on storage Cool and dry storage is recommended. For long period storage, it is important to charge the battery 30 minutes every 6 months. Cautions for dispose When disposing of the light unit, remove the internal rechargeable battery and dispose of it according to local regulations.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
Approximate illumination times based on 60 operations of the Kinetic mode in 1 hour High Low Flashing Rapid Group Ride Daytime HyperFlash : Approx. 1.4 hours : Approx. 6 hours : Approx. 7 hours : Approx. 5 hours : Approx. 5 hours : Approx. 6 hours Standard charging time Approx. 2.
5342730 USB cable (MICRO USB) Limited warranty 2-year Warranty: Light unit only (excludes battery deterioration) CatEye products are warranted to be free of defects from materials and workmanship for a period of 2 years from original purchase. If the product fails to work during normal use, CatEye will repair or replace the defect at no charge. Service must be performed by CatEye or an authorized retailer.
[For US Customers] CATEYE AMERICA, INC. 2825 Wilderness Place Suite 1200, Boulder CO 80301-5494 USA Phone : 303.443.4595 Toll Free : 800.5.CATEYE Fax : 303.473.0006 E-mail : service@cateye.
